Multitech RouteFinder RF802WLC, Quick Start Manual

Page: 14 / 30

9
:LQGRZV0(,QVWDOODWLRQ
Note: Do not insert the
PCMCIA Card
until you are asked to do so.
This may result in unsuccessful installation of your
WLAN PC
card.
Follow the steps below (in the order shown) to install the
RF802WLC card successfully.
1. Verify that there is no
PCMCIA Card
inserted yet.
2. Start your computer.
3. Insert the System CD in the CD-ROM drive and click
Setup
.
4. Accept the license agreement.
5. Select
SSID
. The default is
ESSID
; you can change this later using
the Configuration utility or network configuration. Click
Next
.
6. Select the network type and click
Next
(the default is
Infrastructure
).
7. Give the path of the destination folder. To set the path of your
choice click
Browse
and then click
Next
.
8. Setup adds the program icon to the Program Folder. You may type
a new folder name, or select one from the existing Folder list.
9. It takes a few seconds for copying the utility files. Click
Finish
.
10. Insert RF802WLC card into the slot, the Wizard will find the new
hardware
Wireless LAN 11 Mbps PCMCIA Card
, click
Next
.
11. Choose
Display a list of the known drivers for this device so that I
can choose a specific driver
, then click
Next
.
12. Select
Hardware types
, select
Network adapters
, click
Next
, then
click
Wireless LAN 11 Mbps PCMCIA Card Adapter
. Click
Have disk
then enter the path name. The driver files are copied to your hard
drive.
13. Restart your computer and go to
Start
→
Control
Panel
→
System
→
Hardware
→
Device Manager
.
Find Wireless LAN 11
Mbps PCMCIA Card
in
Network adapters.
If a yellow question mark
(?) displays on the adapter, the installation was unsuccessful.
Select the adapter and click Remove. Then reinstall from step 3.
If your Wireless LAN 11 Mbps PCMCIA Card is installed properly
right-click My Network Place, click Properties to set up local area
connection. Then click OK.
14. Restart your Computer.