MultiVOIP Quick Start Guide
30
Configuring Your Client MultiVOIPs
The client MultiVOIPs can be another MVP 400, MVP 800,
MVP200, or a MultiVOIP 100-series.
If your client MultiVOIP is an MVP 400, perform the following
software loading procedure.
If your client MultiVOIP is an MVP 800, MVP200, or MVP100
series, connect your command port cable and power up the
unit according to the cabling procedure in the approrpriate
MultiVOIP Quick Start. Then configure the unit as a client per
the Software Installation procedures in that Quick Start.
If you are installing a MultiVOIP behind a firewall, you need to
add the following UDP ports to your firewall.
Q.931 Signaling, Ch1[900] Q.931 Signaling, Ch2 [902]
Q.931 Signaling, Ch3[904] Q.931 Signaling, Ch4 [906]
Status [5000]
Ch1 RTP [5004]
Ch1 RTCP [5005]
Ch2 RTP[5006]
Ch2 RTCP [5007]
Ch3 RTP[5008]
Ch3 RTCP [5009]
Ch4 RTP[5010]
Ch4 RTCP [5011]
Refer to your firewall user documentation to enter and open
these ports.
1.
Disconnect the pc from the command port of the Host
MultiVOIP and connect it to the command port on the
Client MultiVOIP.
2. From your desktop, click
Start | Programs I MultiVOIP
800 v. 301F I Upgrade Software
. The following dialog
box displays.
