MultiModem rCell Intelligent Wireless Router
Multi-Tech Systems, Inc. Quick Start Guide
7
For Optional Direct DC Power
●
Screw-on the DC power cable to the power connector on the
router.
●
Then attach the two wires at the other end of the DC power cable
to a DC fuse/terminal block on a vehicle in which you are mounting
the MultiRouter.
●
Connect red wire to the "+" (positive) terminal and black wire to
the "–" (negative) terminal. Be sure the GND connection is correct.
Warning:
Over-voltage protection is provided on the device. To
ensure complete protection, you may want to add additional
filtering to the DC input.
Note:
For an application involving a battery: you can use permanent
“+” or key-switched “+” source. Connect the power supply to its
source (for example, in a mobile situation, to the DC fuse/terminal
block).
Notes
●
The
POWER
LED
.
The
POWER
LED lights after power-up.
●
The
Status
LED is a solid ON when the router is booting up,
saving a configuration, or updating firmware. When the
Status
LED begins to blink, the router is ready.
●
The
Reset
Button
.
Pressing and holding the
Reset
button
for 5
seconds will restore all factory default settings. It also will set the
username and password back to admin and admin as well as
setting the IP address to the default of 192.168.2.1.
Set Your PC’s TCP/IP Address for
Ethernet Functionality
The following directions establish a TCP/IP connection at the pc so the
PC can communicate with the router. The following directions were
written using a Windows XP/ 2003+ operating system.
