If you did not purchase your modem directly from Engineering Solutions it will need
to be authorized for use by the Omniguard. When your modem is connected and the
Omniguard is turned on, you will be informed that the modem is “Not Authorized” along
with a serial number. Contact Engineering Solutions, provide us with the serial number
shown on the screen and we will give the passcode to authorize the modem. To enter the
passcode into the Omniguard use the up and down arrow keys to change a digit and the
right and left arrow keys to move between the digits. When all the digits have been
entered press SAVE to authorize the modem. You will get the message “Modem ready”.
The modem will now work with any compatible Omniguard.
Configuring
Two wireless phone numbers can be programmed directly into the Omniguard. A text
message will be sent to each phone number when the Omniguard enters normal operation
and when an alarm condition occurs. The minimum time between alarm text messages is
limited to the Message Rate to prevent frequent messages if the unit is going in and out of
the alarm state.
Normal Operation Message
JOB:
1234 Jacksonville Ave N
NORMAL OP 12:59:16
Reply with 0 for menu.
Omniguard 4
# G400000
Alarm Message
>> ALARM <<
JOB:
1234 Jacksonville Ave N
ALARM 1: +0.010" WC
12:59:07 +0.011" WC
Reply with 0 for menu.
Omniguard 4
# G400000
Phone numbers programmed directly into the Omniguard will also receive a daily
summary indicating how long the unit was in normal operation, the number of alarms and
the total time the unit was in the alarm state. The summary report will be sent at 5:30pm
each day unless a Notify List has been selected (see below).
Daily Summary Message
DAILY SUMMARY
JOB:
1234 Jacksonville Ave N
IN NORMAL OP:
6hr 46min
ALARMS:
