INSTALLING DRIVERS
MultiConnect
®
microCell MTCM2-L6G1 User Guide
13
Chapter 3 – Installing Drivers
Installing on Linux
The MTCM2-L6G1 is plug-and-play on Linux systems.
Linux Ubuntu 12.04 LTS and 14.04 LTS
Linux Ubuntu 14.04 LTS
After modem hardware is installed, Linux system should show these ports:
One com port = CDC_ACM (/dev/ttyACM0)
Two ethernet ports = CDC_ether (eth1 and eth2)
Use Linux commands below to start cellular connection after modem is setup, configured and registered:
ifconfig eth1 up (cellular IP)
ifconfig eth2 up (debug interface)
udhcpc -i eth1
udhcpc -i eth2
ifconfig eth1 (check if cellular IP address is assigned successfully to this ethernet interface)
You need to setup and configure routing, DNS and default gateway so the system has access over the private LTE
network via the Ethernet cellular IP address interface
Installing Windows Drivers
CAUTION:
If you connected the device before installing the drivers, Windows may install drivers automatically.
Your device may not operate correctly with these drivers. Uninstall the drivers before proceeding.
The driver supports the following Windows versions:.
Windows 10
Windows 8
Windows 7
Before connecting your device.
1.
Click on your model's page at
https://www.multitech.com/brands/multiconnect-microcell
2.
Under
Downloads
, select the sqn_setup_LR4.2.2.0-48388-usb-drivers.exe.
3.
Double-click the exe file to launch the installer.
4.
Click
Yes
and then click
Next
.
5.
Read the license agreement. Select
I accept the agreement
and then click
Next.
6.
Select the
Installation Directory
and click
Next.
To change the default directory:
a.
Click
Browse.
b.
Select a directory.
c.
Click
OK
.
7.
Select the
Start Menu Folder
name. To change the default folder:
a.
Click
Browse.