INSTALLING AND USING THE ECELL
10
MultiConnect
®
eCell User Guide
Using the Setup Wizard
When using a 3G/4G network, verify a SIM card has been installed before powering on and starting setup.
Configure the device using the web UI. To access the web UI, enter the IP Address into your browser. The default
IP Address is 192.168.2.1. If this has been changed, type in the new IP Address.
From the menu on the left, click
Wizard
.
1.
Wait for 60 seconds after connecting power. The computer gets IP address 192.168.2.100 via DHCP.
2.
In a web browser, enter IP address 192.168.2.1.
3.
Login using
admin
as both the
Username
and
Password
. If you are using the default password, it will
prompt you to change it for future logins.
4.
Click
Wizard
on the left.
5.
Click
Next
.
6.
Change password
, if desired and click
Next
. (Recommended)
7.
Set the device's
Time Zone
and click
Next
.
8.
Enter and configure
APN
.
a.
Select
Manual Configuration
.
b.
Set
Country
to
Others
.
c.
Enter the
APN
provided by the SIM provider.
d.
Click
Next
.
9.
Click
Apply
.
10.
Wait a few minutes and check LED status. Power, SIM, Internet, and Signal LEDs are on when there is a
live Internet connection. For more information on the LEDs, refer to
LED Indicators
.
After the device has a valid Internet connection, your computer automatically renews to the new IP address
assigned to cellular connection and have full access to the Internet.