CONNECTIONS:
Torque: 2Nm
Terminal 1: S (connected to L for setback temperature)
Terminal 2: L
Terminal 3: N
Terminal 4+5: NTC - Floor sensor
Terminal 6+7: Max. load 3600W (LOAD)
STARTUP/CLOCK SET
After the thermostat is connected to 230V and you press the
on/off button, the thermostat will switch on at 20°C. The
time display will flash 00:00. The thermostat is now in room
temperature sensor mode with set temperature and the symbol
is shown in the display.
Before programming your thermostat, you must set the clock.
Press the OK button for 5 seconds. When the clock symbol
flahes, press OK once.
Choose whether or not you want to display the time (on/off ).
(Set temperature does not require the clock to be set.)
Confirm with the OK button.
If you choose OFF, the thermostat is ready to be used in set
temperature mode. For use with other modes, choose ON.
Choose the day of the week. 1=Monday, 2=Tuesday etc. Confirm
with OK.
Set the hours and minutes. Confirm with OK. The clock symbol
flashes. Continue to the next paragraph: Choosing a program.
When the
symbol is shown in the display, it indicates that
the heat is on.
CHOOSING A PROGRAM
a) Set temperature
When the symbol
is shown in the display, the thermostat is
programmed to the set temperature option. To switch between
set temperature and weekly program press the OK button and
the left selection button simultaneously for 5 seconds.
b) Weekly program - setback temperature
Press the OK button and the left selection button
simultaneously for 5 seconds.
Weekly schedule is shown with
symbol in the display.
Fig.2
1
2
3
4
5
6
7
OK-button
(changing functions)
Fig.3