PAGE 24 — MQ-WHITEMAN WBH-16EAWD POWER BUGGY — PARTS & OPERATION MANUAL — REV. 5 (01/05/07)
WBH-16EAWD POWER BUGGY — OPERATION
AWD Power Buggy Operation
Pre-Check
1. Engage the
parking
brake lever
(Figure 16)
and attempt to rock the
buggy back and forth.
Operation
Parking Brake/Direction Lever
Before the AWD Power Buggy can be put into operational use, it
is best to perform a test run to make certain that all components
are functioning properly.
1.
Place the AWD Power Buggy on flat solid ground.
2.
Engage the
parking brake lever
.
3.
Place the
engine's throttle control
(Figure 11) in the
SLOW
(idle) position.
Figure 16. Parking Brake Lever
5.
Slowly squeeze the speed control lever slightly (Figure 17),
for a short period of time to test the brake holding capacity.
If the AWD Power Buggy moves forward, adjust the brakes
as outlined in the maintenance section of this manual.
6.
If the AWD Power Buggy does not move forward, release the
speed control, and disengage the parking brake. If the AWD
Power Buggy creeps forward while the parking brake is
disengaged, adjust the
pump control lever stop
until the
creeping is eliminated.
Traction Assist System Switch
When using the AWD Power Buggy, it might become nessesary
to engage the traction assist system to provide a temporary boost
of traction and power while moving through muddy or rough
terrain.
1.
Press and hold the traction assist switch (Figure 19) on the
left hand side of the handle bar to engage the traction assist
system.
Figure 18. Direction Lever
If the wheels turn during the rocking motion adjust the brakes
as outlined in the maintenance section of this manual.
2. Place the
engine's throttle lever
(Figure 11) in the
SLOW
(idle) position.
3. Check the
speed control lever
(Figure 17) located on the
right side of the handle bar. The speed control should work
freely when squeezed by hand, and return to the closed
position when released.
Figure 17. Speed Control Lever
Figure 19. Traction Assist Switch
Operator must
ALWAYS
wear the appropriate
protective equipment and clothing while
operating the AWD Power Buggy.
WARNING:
WARNING:
WARNING:
WARNING:
WARNING:
4.
Place the power buggy's
direction lever
(Figure 18) in the
forward direction.
2.
Release the switch to return to normal operation.
Summary of Contents for Whiteman WBH-16EAWD
Page 3: ...MQ WHITEMAN WBH 16EAWD POWER BUGGY PARTS OPERATION MANUAL REV 5 01 05 07 PAGE 3 NOTE PAGE...
Page 9: ...MQ WHITEMAN WBH 16EAWD POWER BUGGY PARTS OPERATION MANUAL REV 5 01 05 07 PAGE 9 NOTE PAGE...
Page 35: ...MQ WHITEMAN WBH 16EAWD POWER BUGGY PARTS OPERATION MANUAL REV 5 01 05 07 PAGE 35 NOTE PAGE...
Page 69: ...MQ WHITEMAN WBH 16EAWD POWER BUGGY PARTS OPERATION MANUAL REV 5 01 05 07 PAGE 69 NOTE PAGE...