![background image](http://html.mh-extra.com/html/multiquip/sfg10e/sfg10e_operation-and-parts-manual_1855075020.webp)
SFG10E ELECTRIC SURFACE GRINDER — OPERATION AND PARTS MANUAL — REV. #2 (05/28/09) — PAGE 20
INSTALLING A MULTI-ACCESSORY ATTACHMENT (not
including multi-segmented, dry diamond discs) IN THE
ROTATING DISC
Tools Required:
1 Small Hammer
Parts Required:
6 each, P/N 29019-017 Plastic Mounting Wedge
DANGER
DANGER
DANGER
DANGER
DANGER
WHEN INSTALLING A MULTI-ACCESSORY ATTACH-
MENT ON THE SURFACE GRINDER ALWAYS WEAR
THE APPROPRIATE SAFETY EYEWEAR AND AP-
PAREL TO MINIMIZE THE POTENTIAL FROM FLYING
DEBRIS. FLYING DEBRIS CAN RESULT IN PROPERTY
DAMAGE AND/OR PERSONAL INJURY.
1)
Properly disconnect the extension cord or SURFACE
GRINDER from the power source.
2)
Tilt the SURFACE GRINDER back until the operator
handle comes in contact with the surface. Appropriate
wheel chocks are recommended. FIGURE 25.
FIGURE 25
3)
Mount the multi-accessory attachment into the slots
provided in the multi-accessory disc. If the attachment
is directional in design, determine that its mounting
position in the disc allows for proper operation.
4)
Force a Mounting Wedge P/N 229019-017 into the area
between the multi-accessory attachment and the inside
rib of the aluminum disc by hand. The straight side of
the mounting wedge contacts the multi-accessory
attachment. The angled side of the mounting wedge
contacts the rib of the disc. FIGURE 26. An improper
mounting configuration is depicted in FIGURE 27.
ASSEMBLY INSTRUCTIONS/OPERATIONS
Diamond Segment Block
The diamond insert block is designed to compliment the
multi-segmented diamond disc where a quick changeover
feature to other attachments is desired.
Diamond segments are retained into a steel block assembly
and deliver up to 5 times greater productivity rates than the
silicon carbide stones. FIGURE 24. The design resists
clogging while delivering a conservative service life up to
15 times longer than the stones. Diamond is the ideal choice
for larger concrete removal projects and the removal of
epoxies, paints and many thin film coatings.
The concept is especially useful for removing a thin layer of
concrete in final preparation for a new coating application. Can
be used in both wet and dry job applications. Worn inserts are
easily replaced in a matter of seconds. Service life is dependent
upon many variables, but can approach 35,000 square feet
per set, making it a cost efficient solution for many job
applications.
FIGURE 24
FIGURE 23