PAGE 16 —R2000H RIDE-ON STATIC ROLLER — OPERATION & PARTS MANUAL — REV. #4 (07/24/08)
R2000H — GENERAL INFORMATION
Figure 3. Tipping (Rollover)
In the event the roller does tip over, if at all possible, try to shut
down the engine by turning the ignition key to the
OFF
position.
Extreme care must be taken to prevent damage to the engine.
When the roller has been tipped over, oil from the engine
crankcase can flow into the combustion chamber, which can
severely damage the engine the next time it is started.
IMMEDIATELY
after a unit has tipped over upright the unit as
soon as possible to prevent oil from leaking into the combustion
chamber.
NEVER!
operate the roller on
side
slopes
. The roller may tip over
causing injury to personnel and
severe damage to the equipment.
NOTE
CAUTION:
To prevent damage to the engine after a
rollover, the roller must
NOT
be started.
NEVER
start a roller after a rollover.
CONTACT
your nearest authorized Multiquip
dealer for instructions or servicing.
Tipping (Rollovers)
NEVER!
operate the roller on side slopes (Figure 3). The
possibility exist that the roller could tip over (roll over), thus
causing bodily harm even death and serious damage to the
equipment.
WARNING:
This roller is intended to be used on flat
surfaces only.
DO NOT
use this roller near
open trenches, hollow spaces or rocks that
be below surface.
DANGER:
This roller is
not offered
with a
Rollover
Protection Structure
(ROPS). The
possibility exists of the roller tipping over
causing severe bodily harm , even death, if
side-side operation is used (Figure 3).
DO
NOT
use this roller for side to side
applications.
