QP3Ti TRASH PUMP • OPERATION AND PARTS MANUAL —REV. #1 (05/07/18) — PAGE 17
CONTROL PANEL
1.
Starter Switch — Used to engage the battery, start
and turn off the engine.
2.
Oil Alert — Lights up where the oil is low or if there
is no oil.
3.
Pilot Lamp — Indicates operating status. Refer
to Table 6 for the different lamp indicators and
corresponding status.
4.
Auto/Manual Switch — Used to select either Auto or
Manual mode of operation.
5.
Flow Control Switch — Used to adjust flow volume
(this switch only works in Manual mode).
6.
Hourmeter — Indicates total operating hours.
7.
Pilot Lamp Decal — Lists the different lamp indicators
and alerts.
8.
Drain/Fill Switch — Used to select Auto Drain
Operation or Auto Fill Operation.
9.
Float Control Terminals — Provide connection to top
and bottom float switches.
PILOT LAMPS INDICATOR
I ) No Green or Red lights
PILOT LAMPS ALERTS
I ) Red light Flashing in 1 second intervals
Priming Failure.
Inspect hose for kinds, leaks, missing gaskets,
clogged strainer or lack of water.
Check float connections.
II ) Green and Red lights on Flashing in 0.5 sec interval
III) Red light Flashing 2 times, turns OFF for 3 seconds and repeats
Low fuel.
IV ) Red light Flashing 3 times, turns OFF for 3 seconds and repeats
Check electrical connections.
V ) Red light Flashing 5 times, turns OFF for 3 seconds and repeats
ECU error. Contact Multiquip for service.
Engine running.
Auto/Standby.
III ) Green light stays on
IV ) Green light Flashing in 1 second internals
II ) Green and Red lights on
Battery power supply is on.
No Battery power.
1
2
3
4
5
6
7
8
9
Figure 5. QP3Ti Control Panel
Summary of Contents for QP3Ti
Page 2: ...PAGE 2 QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PROPOSITION 65 WARNING ...
Page 3: ...QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PAGE 3 NOTES ...
Page 33: ...QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PAGE 33 NOTES ...
Page 53: ...QP3TiTRASH PUMP OPERATION AND PARTS MANUAL REV 1 05 07 18 PAGE 53 NOTES ...
