MAYCO MG-30 PUMP — PARTS & OPERATION MANUAL — REV. #1 (03/12/03) — PAGE 33
MG-30 PUMP — PRE-INSPECTION (MIXER)
Reference manufacturer engine
manual for specific servicing
instructions.
CAUTION:
Handle fuel safely. Motor fuels are highly
flammable
and can be dangerous if
mishandled.
DO NOT
smoke
while refueling.
DO NOT
attempt to refuel mixer if the engine is
hot or running.
ALWAYS
allow engine to
cool
before refueling.
ENGINE OIL
1.
Remove the engine oil dipstick from its holder (Figure 16).
Figure 15. Adding Diesel Fuel
Figure 16. Oil Filler Port/Dipstick
NOTE
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
NEVER
operate the mixer in
a confined area or enclosed
area structure that does not
provide ample
free flow of air
.
ALWAYS
wear approved
eye
and
hearing
protection before operating the mixer.
NEVER
place hands or feet inside the mixing
drum.
ALWAYS
make sure the
safety grill
on the mixer is locked while the engine is
running.
ALWAYS
shut-down the engine
before performing any kind of maintenance
service on the mixer.
Before Starting
1. Read safety instructions at the beginning
of manual.
2. Clean the
entire mixer
, removing dirt and dust, par-
ticularly the engine cooling air inlet, and air filter.
3.
Check the
air filter
for dirt and dust. If air filter is dirty,
replace air filter with a new one as required.
4.
Check fastening nuts and bolts for tightness.
FUEL
1.
Lift the fuel cap latch located on top of the fuel tank then look
inside the tank and determine if the mixer's engine fuel is
low . If fuel is low, fill with
#2 diesel fuel
(Figure 15). See
Table 4 for other types of recommended fuel.
See Figure 12, page 30 for the location of any control or
component referenced in this section.
Discount-Equipment.com