JS36 SERIES WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #5 (06/02/16) — PAGE 23
5. Grasp the starter grip (Figure 24) and slowly pull it
out. The resistance becomes the hardest at a certain
position, corresponding to the compression point. Pull
the starter grip briskly and smoothly for starting.
Figure 24. Starter Grip
6. If the engine has started, slowly return the choke lever
(Figure 25) to the
CLOSED
position. If the engine has
not started repeat steps 1 through 5.
Figure 25. Choke Lever Closed
7. Before the trowel is placed into operation, run the
engine for several minutes. Check for fuel leaks, and
noises that would associate with a loose guard ring
and/or covers.
OPERATION
Testing the Centrifugal Safety Stop Switch
1. With the engine running at idle, place the safety stop
switch lever in the
"OFF"
position
(Figure 26). Verify
that the engine shuts off. If the engine continues to run,
replace centrifugal safety stop switch.
Figure 26. Testing Safety Stop Switch
2.
Before performing this test, clear the area around the
trowel. Make sure it is free of debris and objects. Move
the safety stop switch lever to the
"ON"
position, restart
the engine and let idle.
Stand behind the handle and spin the handle to the
right, simulating a runaway situation. (See Figure 27).
Centrifugal force should throw the safety switch outward
to the "
OFF
" position thus shutting off the engine.
Figure 27. Testing Safety Stop Switch
Runaway Situation
OFF
KE
EP CLEAR
