![background image](http://html1.mh-extra.com/html/multiquip/globug-series/globug-series_operation-and-parts-manual_1855078016.webp)
GB3LED/B LIGHTING SYSTEM • OPERATION AND PARTS MANUAL — REV. #0 (07/09/15) — PAGE 17
SETUP
BALLOON ASSEMBLY PLACEMENT
1. Place balloon assembly (Figure 8) onto mast and
tighten Upper T-handle.
Figure 8. Light Asembly Placement
2. Unsnap the three buttons on the bottom of the balloon.
Expose the balloon by pulling down on the velcro tab
and unzip the protective cover as shown in Figure 9.
Also remove the AC power cord at this time.
Figure 9. Removing Balloon/AC Power Cord
MAST
UPPER
T-HANDLE
PROTECTIVE
COVER
LOWER
T-HANDLE
ZIPPER
BUTTON
3. Next, fold the protective cover (Figure 10) into itself
and zip.
Figure 10. Folding Protective Cover
4. Attach the S-type hook (Figure 11) on the AC power
cable onto the washer-eylet located on the bottom plate
of the light assembly.
Figure 11. Securing Power Cord
ZIPPER
PROTECTIVE
COVER
S-TYPE
HOOK
WASHER
EYELET
BOTTOM
PLATE
Discount-Equipment.com