![background image](http://html1.mh-extra.com/html/multiquip/ar13d/ar13d_operation-and-parts-manual_1855273026.webp)
PAGE 26 — AR13D RIDE-ON TANDEM DRUM ROLLER — OPERATION & PARTS MANUAL — REV. #2 (09/15/11)
AR13D RIDE-ON ROLLER — OPERATION
OPERATION
Parking Brake
1. To release the parking brake, press and hold the release
button (Figure 21) pull up slightlyon the parking lever, then
push the parking brake lever all the way down.
Shift Lever
1. To make the roller move in a
forward direction
, move the
shift lever forward as shown in Figure 22.
Figure 22. Shift Lever
2. Remember the speed of the roller is directly proportional to
the amount of pressure being applied to the lever in each
direction. Travel speed is between 0 and 4.8 mph (7.2 kph).
3. Try manuvering the roller a few times to get familar with the
handling. Also place the travel lever in the oposite direction
to get acquainted with driving in reverse.
4. Make sure that the roller comes to a complete stop (neutral)
before placing the travel lever in either a forward or reverse
position.
Vibration Button
1. To begin the vibratory action,
press
the vibratory
pushbutton switch located on top of the travel lever as
shown in Figure 23. The pressing of this switch will
generate 3,100 lbs. (1,406 Kg.) of centrifugal force at a
frequency of 4000 vpm (vibrations per minute) to the
front
drum.
ALWAYS
allow the roller to come to a complete stop before
changing the direction of travel. Changing directions before
the roller comes to a complete stop will result in
excessive
force
being applied to the transmission and drive system,
which will reduce the over service life of the system.
Figure 24. Sprinkler Controls
Figure 21. Brake Release Lever
FRONT
BACK
Sprinkler Controls
1. If the application requires the wetting of a surface, front and
rear drum sprinkler controls have been provided. These
controls (Figure 24) are located to the bottom right of the
operators seat. The
front
valve controls the water supply to
the front drum spray bar and the
back
valve contols water
flow to the back drum spray bar.
2. To stop the vibratory action, press the vibratory pushbutton
switch again.
Figure 23. Vibration Pushbutton Switch
CAUTION - Drive System Safety
Summary of Contents for AR13D
Page 3: ...AR13D RIDE ON TANDEM DRUM ROLLER OPERATION PARTS MANUAL REV 2 09 15 11 PAGE 3 NOTE PAGE ...
Page 41: ...AR13D RIDE ON TANDEM DRUM ROLLER OPERATION PARTS MANUAL REV 2 09 15 11 PAGE 41 NOTE PAGE ...
Page 47: ...AR13D RIDE ON TANDEM DRUM ROLLER OPERATION PARTS MANUAL REV 2 09 15 11 PAGE 47 NOTE PAGE ...
Page 91: ...AR13D RIDE ON TANDEM DRUM ROLLER OPERATION PARTS MANUAL REV 2 09 15 11 PAGE 91 NOTE PAGE ...