further source selection to the speakers.
Source Selection
Once you have chosen which signal to route to the display directly below the easy to
read vacuum fluorescent display are 8 illuminated pushbuttons to select which signal
you want to route to the speakers.
In the case of SDI you can have up to 16 channels displayed on pairs numbered 1
though number 8. When in Analog/AES mode the stereo analog input signal will be
displayed on pair 1 and the 75 Ohm AES/EBU input signal will be displayed on pair 5.
Mode Selection
There are also 4 illuminated pushbuttons are for mode selection. Please note that the
unit functions as a stereo audio monitor unless you are using a different mode.
L
The Left channel only is routed to both speakers
R
The Right channel only is routed to both speakers
SUM
Allows the channels to be summed together to monitor more than one
source at a time.
Lt/Rt
Provides an Lt/Rt downmix of your selected 5.1 source. Select the pair
where your discrete 5.1 mix starts then press the Lt/Rt button which
then selects the 2 pairs beside it and creates the downmix from these 6
channels.
Volume Control
The C16C-2 comes equipped with a high quality mil-spec push to mute optical shaft
encoder for the volume control. Finished with a BIG custom machined aluminum knob
for ease of operator use and longevity.
When the shaft encoder is pushed this will mute the audio signal and the speaker
symbol on the display will toggle with the speaker and an X.
Installing a jumper between the I and G terminal of the GPIO 3-Pin connector mutes the
internal speakers and allows the front panel volume control to provide level control over
the external speaker output. Ideal for when you want to control powered speakers.
