Discharging mode
Hot melt extrusion molding
Molding
Three-dimensional
Print range
Unlimited
Feeding speed
Adjustable
Printing material
PLA, ABS
Electric parameter
DC 5V, 2A, 10W
Nozzle diameter
0.6mm
Filament diameter
1.75mm
Filament temperature
ABS 210°C, PLA 175°C
Power adaptor electric parameter
100-240V 50/60Hz 2A
Equipment dimensions
175 x 17 x 20mm
Equipment net weight
40g
SPECIFICATION
loading filament.
•
Insert the 1.75mm filament into the filament loading hole. Keep pressing the filament
loading button and the material will be loaded.
•
Hold until the plastic material comes out from the nozzle. Double click the filament
loading button to load the filament automatically and then press the button again to exit
automatic mode.
Temperature Adjustment
•
To adjust the temperature, open the back cover and use the plastic screwdriver to turn
the temperature switch either clockwise to increase the temperature, or anticlockwise to
reduce the temperature.
•
Note: each level is 15°C and the temperature range is from 130°C to 240°C.
Speed Adjustment
•
Slip the speed controller to adjust the speed.
Unloading Filament
•
To unload the filament keep pressing the unload filament button. Double click the button
to unload the filament automatically and press the button again to exit the automatic
mode.
Replacing the Nozzle
•
Open the back cover using the plastic screwdriver and remove the screw, before
removing the nozzle.
•
The pen will enter standby mode after 2 minutes of no operation. Press the load filament
button to wake it up.
•
Do not touch the nozzle during working.