Page <2>
V1.0
06/04/22
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
sg.element14.com/b/multicomp-pro
Soldering Iron Tip Replacement
• Replacing the soldering iron tip should only be done when the iron Is switched oft and at room temperature.
• The tip can be changed or replaced by unscrewing the knurled nut barrel.
Caution:
Damage could occur if the iron is left on without the tip inserted.
• After removing the tip, blow out any remaining oxide dust that may have formed in the tip retaining area of the barrel.
Warning:
Care should be taken to avoid getting dust in your eyes.
• Replace the tip and tighten the knurled nut barrel assembly with your fingers.
• Pliers should only be used to tighten the nut if loosening occurs when the iron is hot.
• Do not over tighten the nut as the element could be damaged.
Cleaning
• Cleaning should only be done when the power is switched off and the iron is at room temperature.
• Use a damp cloth and a small amount of liquid detergent if necessary.
• Do not use any chemicals, abrasives or solvents that could damage the soldering iron.
Specification
Voltage
20V AC to 240V AC
Power
65W
Temperature Range
250°C ro 480°C
Temperature Accuracy
±10°C
Temperature Stability
±2°C
Heating Element
4 core PTC heater
Heat Indication
Blue LED
Temperature Units
°C/°F
Indiction
LCD
Important Safety Information
Please read these instructions carefully before use and retain for future reference
• When using electrical appliances basic safety precautions should always be followed.
• Check that the voltage indicated on the rating plate corresponds with that of the local network before connecting the
appliance to the mains power supply.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
• Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are
older than 8 and supervised.
• Do not operate the appliance with a damaged plug or cord, after a malfunction or after being dropped or damaged in any
way.
• If the supply cord is damaged, it must be replaced by a qualified engineer in order to avoid injury or a hazard.
• Ensure there is sufficient space and ventilation around the appliance to allow the escape of heat and/or fumes.
• Do not expose to rain or moisture.
• Never place the product or part of it in water, or operate if your hands are wet.
