6
GROUNDING FUNCTION
3. Standby Delay: Turn on and off the standby timer function.
The product automatically enters into the standby state based on the set delay
value (unit: 1~120 minutes) if the iron is idle for a long time.
The factory default is OFF so the soldering iron will not enter into the standby
state.
4. Shutdown Delay: Turns on or off the safety shut down timer function.
The product automatically enters into the shutdown state based on the set delay
value (unit: 1~120 minutes) if the iron is idle for a long time.
The factory default is OFF so the soldering iron will not enter into the shutdown
state.
5. Shortcut Temp 1: Allows adjustment of the preset temperature 1.
6. Shortcut Temp 2: Allows adjustment of the preset temperature 2.
7. Shortcut Temp 3: Allows adjustment of the preset temperature 3.
A total of 3 preset temperatures are available for users to quickly call subject to the
temperature lower limit and temperature upper limit settings.
8. Fix Temp: After this mode is activated, the tip temperature is locked at this preset
value. Users cannot adjust the temperature in the main interface.
9. Temp UL: the highest temperature that the user can configure in the main working
interface.
10. Temp LL: the lowest temperature that the user can configure in the main working
interface.
The maximum configurable maximum temperature is: 480°C / 896°F.
The maximum configurable minimum temperature is: 150°C / 302°F.
The setting for the temperature upper limit must be higher than the temperature
lower limit value.
The factory default upper value is: 450°C / 842°F.
The factory default lower value is: 150°C / 302°F.
•
To store all changes, select “EXIT” and press “Enter”
•
This product uses 3.5mm grounding plug, which provides the following four
grounding modes:
When the equipotential bonding mode is chosen: the
ground wire can achieve the required function by being
connected to either pins 1, 2 or 3.
