22
The 'Open Collet' signal means that there has been an attempt to
switch on the rotation without a tool or with an open collet clamp.
In order to deactivate the 'Open Collet'
emergency mode, the following must
be done:
1. Switch off the rotation
2. Insert a tool
3. Lock the collet clamp
4. Resume the operation
Pedal Operation
Connect the relevant plug of the pedal to the relevant jack at the
back panel of the power unit and place the pedal in a location
suitable for work. Press and hold the pedal with your foot to start the
rotation of a tool. Release the pedal to stop the rotation.
Attention!
The pedal only reacts to closure and opening of the
electric contacts. No changes occur to the rotation speed of a tool.
Maintenance
Very important!
All types of preventive maintenance must be
performed only when the Milling Cutter is disconnected from the
power supply and unplugged from the wall socket! An accidental
switch-on of the Milling Cutter during maintenance may result in
injury, electric shock or damage to the device.
Prior to any operation of the Milling Cutter, always check the casings
of the power unit and of the handheld milling cutter, the connection
cables, and the power cable. If any damage is found, contact the
Service Center for replacement.
WARNING!
Operation of the device is prohibited until the damaged
parts are duly replaced!
