Multibor - Suite technology
The quality and the speed of performance of the procedures depend
both on the skills of a master and on the correct combination of the
equipment and materials as well as on the output power of the
milling cutter, the shapes and sharpness of the caps, the tool rotation
speed, and the pressure on the nail plate or the foot of a client.
The Multibor-Suite technology combines the technical capabilities of
the equipment, the specifics of usage of the tools for
machine-assisted nail care, the present-day requirements of a client,
and the skills of a master.
Your milling cutter operates according to the Multibor-Suite
technology in the Program Mode.
This enables you to use the table for correct operation of the device
in accordance with a pre-selected program for a specific procedure.
The processor will further automatically select the required speed,
the output power, and the torque, and it will also supervise and
control all required changes in the course of the operation, smoothly
adapting to your manner of performing the procedure.
Control programs and their respective tools can be found on the
second page.
18
Program Control Mode "Programs"
Press the 'M-button' to select operation modes under the preset
programs.
While in the 'Programs' mode, the display shows a character to
indicate a specific program and a digit to indicate the program's
number.
Select a desired program by rotating the Manipulator.
Press the center of the Manipulator for one time to start the rotation.
Attention!
The rpm rates and the programs cannot be changed on
the go. Stop the rotation to change a program. While a program is in
operation, it is only possible to change the rotational direction by
pressing the center of the Manipulator for two times at a run same as
you double-click on a computer mouse.
Very important!
Follow the safety precautions!
It is allowed to unlock the clamp or to change a tool only after the
rotation is fully stopped.
Program H6
“Reverse” - OFF
Program P7
“Reverse” - ON
