MISG-IO-M
!
!
i
- This operating manual gives important handling instructions for the strain gauge amplifier. Compliance with all
safety and handling instructions in this manual is a requirement for safe work.
- Qualified personnel must have read and understood this operating manual before mounting and start-up of the
sensor.
- This operating manual is part of the product. Please keep this manual at a place accessible for all users and on-
site.
- Please comply with the local regulations and safety instructions for the field of application of this sensor.
- If the serial number on the product label becomes illegible (e.g. through mechanical damage), traceability can
not be ensured.
- The strain gauge amplifier MISG-IO described in this manual is carefully designed and manufactured using
state-of-the-art technology. Every component undergoes strict quality inspection in all stages of manufacture.
- The manufacturer's liability is void in the case of any damage caused by using the product contrary to its
intended use, non-compliance with this operating manual, unauthorised modifications to the MISG-IO or
assignment of insufficiently qualified skilled personnel.
U+:
Positive supply connection
U-:
Negative supply connection
C/Q:
IO-Link
1 General
Strain Gauge Amplifier IO-Link
Page-3
1.1 Information
1.2 Signs and Abbreviations
Warning!
Noncompliance can cause injuries to persons and/or the demolition of the device.
There can be a danger to life.
Attention!
Noncompliance can cause faulty device operation or lead to property damage.
Information!
Noncompliance can influence the operation of the device or cause unintentional reactions.
Danger!
Failure to comply with the safety instructions risks serious or fatal injury caused by electrical power.
Warning!
Possible dangerous situations caused by hot surfaces or liquids, which can lead to burns. Please
avoid hot surfaces and liquids. .
Warning
Danger
Warning
For long-term storage, please avoid the following influences:
- Direct sunlight or proximity to hot objects
- Mechanical vibration, mechanical shock (rough mounting)
- Soot, steam, dust and corrosive gases
If possible, store the device inside its original packaging or equivalent
Do not remove packaging until just before mounting. Keep the packaging as it will provide optimum protection during
transport (e.g. change in installation site, returns).
Check the device for any damage that may have been caused during transportation. Report obvious damage at once.
2.1 Transport
2.2 Packaging
2.3 Storage
2 Transport, Packaging, Storage
