Muller licht Petunia 404040B, Instruction Manual

Page: 38 / 44

38 ENGLISH
3. The tint product is found by the app within a few seconds and flashes briefly
for confirmation. Depending on the app, the search takes a few seconds after
which the tint product is displayed in the app as a new device and can be named
as required.
The tint remote control can also be integrated in some Zigbee gateways, so that
LED bulbs and remote control can be used in parallel.
Instructions and further information can be found at
www.mueller-licht.de/tint
RESET
Reset to 100% light
The tint light bulbs and luminaires can be easily reset by light switch to the basic
setting of warm white and 100% brightness. This may be necessary, for example,
if you have dimmed the tint products before and the remote control‘s batteries are
empty. This feature may also be used in the normal case if you do not have the tint
remote control on hand.
1.
Use the light switch to switch the tint product off and on again 3 times (interval
of 1 second).
2. The tint product will now start in its basic setting, warm white, 100%.
Resetting the tint product
Resetting the tint product is only required in exceptional cases, such as when the
remote control has had to be reset.
Note: All settings (such as the link to the remote control) are reset. The tint prod-
uct is then returned to coupling mode.
1. Switch the tint product on and off 5 times (interval of 1 second).
2. The reset has occurred as desired. Wait for 20 seconds and you can now use the
tint product as normal using your remote control or other Zigbee system.