MANUAL
LED-STRIP · RGB
english
15
4. Close the connector (Fig. 3) and check, if the strip is fixed properly.
Please pay attention to the correct polarity, plus may only be
connected with plus and so on.
5. Connect the repeater to the strip (consider the arrow markings).
6. Connect the repeater to the line adapter.
7. Connect the line adapter to the power socket.
8. Remove the contact protection in the battery compartment.
9. Start the LED strip by using the remote control.
10.
Advice:
Receiver for the infrared-signals of the remote is the
repeater. The remote control need a direct and barrier-free
connection to the repeater. Max. distance 5-7 m.
Battery replacement
Please open the battery compartment on the side of the remote
control by pushing the clamping pin by simultaneously
extracting the compartment.
Please always use an identical battery of type CR2025 · 3 V.
Please consider correct poling by placing the battery in the
compartment. The side of the positive pole is marked by (+)
on the compartment.
Fig. 3
400092_LED-Strip_RGB_MANUAL_010.indd 15
14.03.17 13:15
