T H E W O R L D P O W E R I N A N C H O R I N G S Y S T E M S
HFF600S MANUAL
WWW.MUIR.COM.AU
Page:
10
Maintenance & servicing - HFF 600 Free Fall Windlass
1.
You will require the following tools to complete this
procedure:
(i) Muir Clutch handle (P/N. F90-HANNYL0600)
(ii) Flat blade screwdriver
(iii) Phillips head screwdriver
(iv) 3/16” Allen key
(v)
1/8” Allen key
(vi)
A Lithium/Teflon based marine grease.
(vii)
HFF 600 Exploded view Dwg. K08-FREHFF
2.
Removing Declutching Pawl (P/N. P13-PWL316HFF600) &
SHC Screw (P/N. S45-30406.35019). Place 3/16” Allen key
into (A) SHC Screw and turn anti-clockwise to remove.
Now the Declutch can be removed.
3a. Removing Clutch Nut (P/N. P07-CLNBRZHFF600), SHC
Screw (P/N. S45-30406.35013) & Retaining Washer (P/N.
P21-304019.2007.012). Place 3/16” Allen key into (B) SHC
Screw and turn anti-clockwise to remove.
3b. Now place the Clutch Handle (P/N. F90-HANNYL0600)
into (C) bi-square and turn anti-clockwise to remove.
Note: After Declutcher and retaining washer has been
removed the clutch can now be engaged and
disengaged manually (if required).
4. Releasing
Finger
(P/N. R40-FGRPVC0600A). Place 1/8”
Allen key into (D) Grub screw (P/N. S35-3040635006) and
turn anti-clockwise to release. With the tension released
from the finger it can be pivoted out of the way.
Note: upon re-assembly don’t over tension the Finger
Pin (P/N. P15PIN30415.88X41). With line removed from
the gypsy, place Screwdriver (flat blade) into slot (E)
and turn it a ¼ turn in the clockwise direction then hold.
Now place 1/8” Allen key into (D) Grub screw and turn
clockwise to tighten.
C
B
E
D
A
