T H E W O R L D P O W E R I N A N C H O R I N G S Y S T E M S
F
H
G
I
J
K
5.
Removing PVC finger
(P/N. R40-FGR3160600A).
Place 3mm (1/8") allen key into (F) grub screw
(P/N. S35-30406.35BSW006) and then turn anti-
clock wise to remove. The finger can now be
removed.
Re-assembly:
Tensioning the finger: Place flat
bladed screwdriver into (I)
slot of Pin, then turn
anti-clock wise ¼ turn & hold. Then tighten (F)
Grub screw.
6.
Removing clutch cap
(P/N. P07-
CLNBRZVFF600A1). Place Muir clutch handle
into bi-square (G) and then turn
clockwise
(left hand thread) to remove.
7.
Removing gypsy
(P/N. P10-A0600), peeler (P/N.
P05-PLR3160600) & stripper (P/N. P19-
STR3040600A). These parts can now be slid off
the main shaft (H).
Re-assembly:
When placing gypsy back on
the shaft make sure that the notches are on
top.
•
Before re-assembly, grease the exposed
main shaft/cone (J) & gypsy bore (K).
•
The Motor/geardrive assembly should be
protected with anti-corrosion film or grease
tape.
VR/VRC/VFF 600 12/01/2015
muir.com.au
13
