4
INSTALLATION:
Step 1
– First determine where you would like to
place the speaker and at what angle the speaker
will be mounted. Place enclosure on bar with
desired angle and make a mark in the middle of
the wire hole on the bar. This mark will be where
the speaker wire will come thru the bar into the
enclosure.
Step 2
– Drill a
3
⁄
8
" hole for the speaker wire on the
mark that you made. Deburr the hole to keep from
damaging the speaker wire. Treat the hole with a
paint or sealer to inhibit corrosion.
Step 3
– Connect the safety tether
Drill out safety tether hole using a
1
⁄
4
" drill bit on
enclosure depending on which side you would like
to mount the tether. Loop safety tether around Bar.
Next place tether bolt through tether ring and
rubber washer. Then put bolt through drilled hole
on enclosure and secure with metal washer and
locknut. Let enclosure hang by tether until next step.
