8.14 Oil Filtration / Cooling
8.14.1 Engine oil filter – Replacement
Preconditions
☑
Engine is stopped and starting disabled.
Special tools, Material, Spare parts
Designation / Use
Part No.
Qty.
Filter wrench
F30379104
Engine oil
Oil filter
(→ Spare Parts Catalog)
WARNING
Oil is hot.
Oil can contain residue/substances which are harmful to health.
Risk of injury and poisoning!
• Allow the product to cool to below 50 °C before beginning work.
• Wear protective clothing, protective gloves and goggles/safety mask.
• Avoid contact with skin.
• Do not inhale oil vapor.
NOTICE
Inadequate oil pressure during the engine start sequence following an engine oil change or an engine oil
filter replacement.
Risk of severe engine damage!
• Make sure the quick-start function is deactivated before starting the engine.
• For engines with lube oil priming pump: Prime the engine for 20 seconds at a pressure of at least
0.3 bar.
Engine oil filter – Replacement
1.
Remove engine oil filter using the filter
wrench.
2.
Clean the sealing surface on the connecting
piece.
3.
Check sealing ring (1) of new engine oil filter
and apply a thin coat of engine oil.
4.
Check inscription on filter: must be “Oil Fil-
ter”.
5.
Screw on and tighten engine oil filter by
hand.
6.
Replace other engine oil filters in the same
way.
Note:
• Observe the following instructions to avoid
engine damage: Adequate oil pressure for
an engine start is only provided when the
quick-start function is deactivated.
• See label (2) on filter housing.
7.
Make sure the quick-start function is deacti-
vated before starting the engine.
8.
Check engine oil level (→ Page 237).
MS15039/01E 2018-11
| Oil Filtration / Cooling | 241
TIM-ID: 0000082264 - 003
