BL-2 Diesel Engine
41
Lights
Solution
One of my lights is out.
Most likely you had been running the engine in
DCC or DCS mode and toggled that light off. Put
it back into one of those modes and turn that
light back on. The engine will remember that
when you run it again in Conventional DC.
None of my lights are on.
See “One of my lights is out”
Is the engine getting power? Check to see if
there if voltage on the track or move the engine
a few feet in either direction.
Motion
Solution
When I apply power to the track my engine
starts up (lights and sound) but it won't move
Lower the track voltage then raise it again. The
engine should start moving. If you apply greater
than 9VDC quickly the engine will just sit there.
Lowering it below 9VDC then raising it will get
the engine moving.
My engine hesitates at slow speeds.
An engine may do this right out of the box if it
has not been lubricated. Follow the lubrication
instructions. Now go ahead and run it.
New engines even after they are lubricated may
take a little bit to get everything run in. Be a little
patient and let it run for a bit. It should clear up
shortly after lubricating and running.
Conventional DC
Summary of Contents for 20-20701-1
Page 20: ...BL 2 Diesel Engine 20...
Page 47: ...BL 2 Diesel Engine 47...
