MTD L 17, Original Operating Instructions

Page: 22 / 136

22
Operation
EN
Attaching the transport wheel
A F
Î
Place the transport wheel
A
c over the front
vacuum/blow pipe and push it up to the marked
stop [1]
F 1
.
Î
Fix the transport wheel with the screw
A
i
F 2
.
Attaching the deflector pipe
A G
Î
Press the deflector pipe
A
e onto the
housing
G 1
with the opening facing forwards.
Attaching the vacuum bag
A H
Î
Hook the front part of the vacuum bag adapter
A
f
onto the connecting piece of the housing
H 1
.
Î
Press the rear part of the vacuum bag adapter
onto the connecting piece of the housing until it
audibly latches in
H 2
.
Î
Attach the vacuum bag to the fastening
hook
H 3
.
Fixing the carrying belt
A I
Î
Attach the carrying belt
A
g to the fastening point
provided
I 1
.
Note
For safety reasons only carry the device
supported over your shoulder and never
around your neck.
Adjust the carrying belt
J
Î
Shut the belt closure
1
.
Î
Adjust the carrying belt to the desired length
2
.
The attachment hook should be at hip height.
Note
In order that you have better control over the
device and so that your arms and back do
not tire too quickly, the carrying belt must
always be used with the device.
Inserting the power pack
K
WARNING!
Incorrect handling of the power pack and
the charger
Â
Risk of injuries and material damage
¾
Read and observe the operating
instructions of the power pack and
charger.
Î
Push the power pack into the power pack com-
partment, until it audibly engages
1
.
ü
The power pack is in operating mode.
• The electrical contacts are closed and the de-
vice is ready for use.
Operation
Operating times
Î
Observe local regulations.
Î
Check with your local authorities to determine if
there are any operating time limitations.
Selecting the operating mode
L
Î
Set the selection lever to the desired operating
mode.
NOTE
The selection lever can also be adjusted
during operation. Turn the selection lever,
always ensuring that it engages with the
corresponding symbol. Never move the
selection lever to an intermediate position.
- Vacuum function: Set the selection lever to po-
sition
1
.
- Blow function: Set the selection lever to posi-
tion
2
.
Switching on the device
L M
Î
Select the required operating mode
L
.
Î
Press the on/off switch on the handle
M 1
.
Î
Turn the rotary switch backwards to increase
motor speed
M 2
.
The further back, the higher the motor speed
(blow/vacuum function).
ü
The device is ready for operation.