7
•
Locate auger control grip, part #4 in Figure 1. The
triangular metal tab on the auger control grip must
face the center of the handle panel.
•
Insert curved end of the Z fitting into the top hole in
the triangular metal tab on the auger control grip.
See Figure 3.
Figure 3
•
Place the auger control grip on top of the left
handle. The triangular metal tab must be between
the handle and the grip bracket. See Figure 4.
Figure 4
•
Secure with hex bolt, spacer, and hex lock nut. See
Figure 4. (Do not overtighten this bolt as it will
prevent the grips from automatically returning to
their upright position.)
•
Repeat process for the right side Traction Control
Grip.
•
Lay handle assembly behind snow thrower. See
Figure 5.
Figure 5
•
Insert a hex bolt 3/4” long and lock washer through
the lower hole on the bottom of the handle. See
Figure 5.
•
Hold the handle assembly up to the bottom of the
snow thrower frame and thread the hex bolt into the
lower hole in snow thrower frame. Do not tighten at
this time. See Figure 6.
Figure 6
•
Repeat process on the other side.
•
Raise the handle assembly into the upright position
and align the top holes in the handle with the top
holes in the snow thrower frame. Attach using hex
bolts 2” long, lock washers and saddles. (Curve in
saddle must match the curve in the handle.) See
Figure 7.
Auger Control
Grip
“Z” Fitting
Triangle
Metal Tab
Auger Control Grip
Left Grip Bracket
Handle
Panel
Hex
Spacer
Hex Lock Nut
“Z” Fitting
Left
Handle
Bolt
Triangle
Metal Tab
Hex Bolt
Lock Washer
