Controls and Features
4
10
Chipper Chute
Allows twigs and small branches up to 2” in diameter to be fed
into the impeller for chipping.
Hopper
Allow leaves and small branches up to 1/2 diameter to be fed into
the impeller for chipping and shredding. Material can be raked
into the hopper by lowering it down to the ground.
Release Rod
The release rod is located on the impeller bracket assembly and it
is used to release or lock the hopper when raising or lowering.
Discharge Chute
Debris exists the machine’s reduction chamber through the
discharge chute.
Oil Fill Cap
Remove oil cap to add oil. Refer to the Maintenance & Service
section for checking and adding oil instructions.
Fuel Fill Cap
Remove the fuel cap to add fuel. Unit runs on regular gas.
Engine Controls
See the engine Owner/Operator manual packed with your unit
for the location and function of the controls on the engine.
Hopper
Discharge Chute
Chipper Chute
Release Rod
Fuel Fill Cap
Oil Fill Cap
Figure 4-1
Summary of Contents for 45M4 Series
Page 19: ...Notes 10 19...
