8
S
ection
4 — A
SSembly
& i
nStAllAtion
6.
If not already flipped forward, flip seat
forward to allow for the grass bags and
upper tube assembly steps.
7.
Open bagger cover by pushing in on the
rear, right-side tab with your right hand,
as shown in (1) of Figure 4-8, and lifting
the cover with your left hand in the center
rear of the bagger cover (2).
1
2
Figure 4-8
8.
Install both grass bag assemblies, with
the tight mesh sides facing forward, onto
the bag support brackets by inserting the
front edge in first, as shown in Figure 4-9,
and setting the back edge down until it
fits into the assembly.
1
2
Figure 4-9
Installing the Deck Chute
1.
Determine whether your deck is a 42” or
46” model. As shown in Figure 4-10, a 46”
deck will have a mounting tab with 1 hole
(1), while a 42” deck will have a mounting
tab with 2 holes (2).
1
2
Figure 4-10
2.
If your mower deck is 46”, you will need
to remove the 42” deck boot adapter that
is pre-installed in this kit. Remove 3 nuts
(712-0380) and 3 T30 screws (710-1193A),
and then slide out the boot adapter from
boot. Re-install 3 nuts (712-0380) and
3 T30 screws (710-1193A), as shown in
Figure 4-11.
Figure 4-11
3.
Install the rubber chute straps, from
hardware pack 689-00579, onto the chute
elbow using the clevis pin (711-05063),
washer (736-0204) and Bow-tie cotter pin
(714-04040) from the hardware pack. See
Figure 4-12.
Figure 4-12
4.
Secure the chute elbow to the deck by
aligining the tab slot in the boot, and the
tab located on the mower deck as shown
in Figure 4-13.
5.
With the tractor’s discharge chute raised up
and held open (1), install the chute elbow
shown in Figure 4-13.
1
2
Figure 4-13
Summary of Contents for 19A30034000
Page 11: ...19A30034000 6 10 18 12 15 19 17 16 16 15 19 14 14 17 8 13 3 2 4 9 7 11 6 5 1 11...
Page 13: ...13 Notes...
Page 25: ...19A30034000 6 10 18 12 15 19 17 16 16 15 19 14 14 17 8 13 3 2 4 9 7 11 6 5 1 11...
Page 38: ...19A30034000 6 10 18 12 15 19 17 16 16 15 19 14 14 17 8 13 3 2 4 9 7 11 6 5 1 11...