User’s Manual
PSE-SW5G25B4-IP66
MSTRONIC CO., LTD.
4
UPLINK (P5)
PoE In
Yellow
Powered from another PoE,
Powered via all 4 pairs.
Yellow
Blinking
Powered via 2 pairs, data pairs (pin 1,2,3,6) or
spare pairs (pin 4,5,7,8) are all acceptable.
Off
No power is detected on this port.
*Power wiring
The PoE switch allows to be powered by another PoE source on port 5 (UPLINK) and/or on rear
terminal,
If powered on port 5 (UPLINK) as a PoE repeater, the PoE input must be 44~57VDC, the input
current should not be over 2Amp.
If powered via the rear terminal, please make sure the input current isn’t over 15A.
Model
Input Voltage
(REAR)
Input Voltage
(Port 5)
Output voltage
PSE-SW5G25B4
11-36VDC
No input
56VDC
(regulated)
No input
44-57VDC
44-57VDC
(non-regulated)
11-36VDC
44-57VDC
56VDC
(regulated)
For PoE operation, total output is 35W (802.3at) x 2 or 17W (802.3af) x 4. Please note that the full
load output is only when using 24VDC (or above) input voltage. If your input is 12VDC, then the
total load should be de-rated.
Ports 1~4 will deliver DC power over the Ethernet cable as detailed below:
