7
(a)
(b)
(c)
14
6.5 Connect the control panel to the control box.
Fasten and secure the rings to the pipe adapter
on the spa tub. (Figure.6.5) Make sure the
rubber O-rings are properly placed on the air
pipes. Close the panel zipper cover once the
panel is installed.
CAUTION:
Lost of the O-rings may result spa
and the bubbling function working improperly,
and also cause the air pump rusted. (Spare
O-rings can be founded in the package).
O-rings
Air pipe
6.5
7.
Spa Bladder Inflation
a) Open the air valve (a) on the bladder. Insert the
inflation hose (b) into the valve.
b) Press the Bubble button to inflate until it is
firm to touch but not hard.
c) Press Bubble button for more than 3
seconds to turn off the function. Disconnect the
inflation hose from the air blower outlet and the valve
d) Replace the air valve cap (c) back on the control
panel. Close and recess the inflation valve (a).
8.3 Place the inflated air bladder and the top lid cover over the spa tub, and make sure the spa cover are
closed with buckles and lock the buckles by the key.
NOTE: Deflation Instruction
Spa Bladder Deflation
1. Pull the valve cap out and squeeze the valve at its base until deflated.
2. Close and recess the valve back.
8. Water Filling
8.1 Check the spa liner is at the selected area and point the rain valve
toward a suitable draining area.
8.2 Fill the spa tub with fresh water to a level between
Minmum
and
Maximum
line marked on the
inside of the spa wall. Do not over fill the spa. It is
recommended to fill the spa with lukewarm water
for quick heating and energy saving.
WARNING:
● Water level must reach the
Minmum water line but not exceed the Maximum line to avoid
pump failure.
● Never pour water with a temperature higher than 40°C(104°F) into the spa directly.
● To avoid control system failure, do not operate the spa until water reaches the
Minmum line.
8.2
Summary of Contents for PM-610S Tuscany
Page 24: ......
