15
DISPOSAL AND ENVIRONMENTAL PROTECTION
This marking indicates that the product should not be disposed of with other household waste. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle the product responsibly to promote the sustainable reuse of
material resources. Information on disposal can be obtained from your local authorities.
To return your used device, please use the return and collection systems or contact the retailer where the product was purchased for
environmentally safe recycling.
TROUBLESHOOTING
LED READING
CAUSE
SOLUTION
- - - / 888 / EEP
F0
F1
Contact local MSpa Service Center
Contact local MSpa Service Center
Change the water
Contact local MSpa Service Center
Clean the parts and tubes that the water goes through
1. Add more water to the minimum line
2. Clean the parts and tubes that water goes through
3. Contact local MSpa Service Center
ERROR CODE CHART
Signal wire is loose
Communication failed
Water temperature is below 0°C (32°F) or exceeds 50°C (122°F)
Temperature sensor failure
F1 immediately shows after pressing FILTER , HEATING or UV
F1 shows 15s after pressing FILTER, HEATING or UV
PROBLEM
CAUSE
SOLUTION
NO DISPLAY ON THE
CONTROL PANEL
SPA LEAKING
NOT HEATING
PROPERLY
Change a socket or repair the socket before use
Reset the GFCI by following the GFCI Testing section
Contact local MSpa Service Center
Contact local MSpa Service Center
Tighten the in&outlet connection
Close the drainage valve. Contact the MSpa Service Center,
if spa is still leaking
Repair the leaking hole/split with the repair kit material
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact local MSpa Service Center
Refer to the "FILTER PUMP DOES NOT WORK" section
Power socket failure
GFCI is off
Press the Reset button, controller is not displayed
GFCI broken
Spa in&outlet connection not securely tight
Drainage valve is not closed completely
Water leaks from the spa pool body
Temperature set too low
Dirty filter cartridge
Water level is not at the minimum water line
Heater failure
Filter pump DOES NOT WORK
SPA LOSES AIR
WATER NOT CLEAN
Inflate the spa till Yellow section of the manometer is pushed out.
Make sure the valve is screwed tightly. Replace the valve if necessary.
Fill a squirt bottle with soapy water and spray on the seams. If there is a
leak, small bubbles will come out. When you have located the leak,
clean and dry the leaking area, then use the repair patch supplied with
your spa. Check the repair section on P15.
Change the water
Extend the filtration time
Clean or replace the filter cartridge in time
Refer to the chemical manufacturer’s instructions
Air valve is loose
Hole or split on the spa tub
Water has been used for long
period of time
Insufficient filtering time
Dirty filter cartridge
Improper water maintenance
