11
Cleaning the spa
Detergent residues and dissolved solids from bathing suits and chemicals will gradually accumulate in the
Spa’s water. If there is a lot of dirt in the water, try and get it out or change water and clean the pool. Use
a mild soap and water solution to wash the vinyl then rinse with freshwater and drain this out before you
fill up your MSpa with new fresh wate
r.
NOTE:
Do not use hard brushes or abrasive cleaners.
Special Notice on Water Treatment
Please read about water quality and filter in user manual. Always shower before you enter your MSpa!
Please use test strip to test your water chemistry before each use of the spa, no less than once per week.
The pH level must be between 7.2 and 7.8, total alkalinity between 80 and 120ppm and free chlorine
between 3 to 5ppm. Too low of a pH level will result in excessive wrinkles and damage to the spa pool as
well as corrosion in the motor unit. Too high of a pH level(hard water) will result in scale incrustation, e.g.
sheets of white coagulations inside the filter pump, which will lead to block and non-working of the filter
pump.
If you have any questions regarding chemicals, please contact local spa and pool water treatment specialist
stores.
It is the responsibility of the owner to properly maintain the chemical balance and sanitation of the water.
Mspa is not responsible for any damages that result from improperly mantained water. Improper water
maintenance may result in voiding the warranty.
Drainage
1. Turn off all the functions on the control panel.
2. Connect the drainage hose adapter onto the drainage structure and
make sure it is well connected.
3. Find your garden hose and connect onto the drainage hose adapter
in the other end.
4. Screw off the cover of the drainage structure inside of the spa pool, let the
water flow out of the drainage hose.
5. Wait till the spa has no water flow out of the drainage hose, empty the
the rest of water manually and completely.
If you are going away for some weeks and nobody can follow up the water treatment
program in your MSpa, please drain out the water before leaving and take out some
air pressure.
Spa Pool Repair
If the Spa is torn or punctured use the provided Repair Patch. Dry the area to be repaired. apply the glue
for PVC to PVC to the repair patch and then attach it onto the damaged area. Smooth the surface to
remove any air bubbles. A secure unnoticeable repair can usually be made.
Meijer.com
