C-9
Intel ICH9R SATA RAID
Installing Driver
Install Driver in Windows Vista / XP / 2000
†
New Windows Vista / XP / 2000 Installation
The following details the installation of the drivers while installing W indows XP /
2000.
1. W hen you start installing Windows XP and older operating systems, you may
encounter a message stating,
“
Setup could not determine the type of one or
more mass storage devices installed in your system
”
. If this is the case, then
you are already in the right place and are ready to supply the driver. If this is
not the case, then press F6 when prompted at the beginning of W indows
setup.
2. Press the
“
S
”
key to select
“
Specify Additional Device
”
.
3. You should be prompted to insert a floppy disk containing the Intel
®
RAID
driver into the A: drive.
Note:
For W indows Vista you can use Floppy, CD/DVD or USB.
Important
Please follow the instruction below to make an
“
Intel
®
RAID Driver
”
for
yourself.
1. Insert the MSI CD into the CD-ROM drive.
2. Click the
“
Browse CD
”
on the Setup screen.
3. Copy all the contents in
\
\IDE\Intel\ICH9R\Floppy
to a formatted floppy
diskette.
4. The driver diskette for
Intel
®
ICH9R RAID Controller
is done.
4. For W indows Vista:
During the Operating system installation, after selecting the location to install
Vista click on
“
Load Driver
”
button to install a third party SCSI or RAID driver.
5. W hen prompted, insert the floppy disk or media (Floppy, CD/DVD or USB) you
created in step 3 and press Enter.
6. You should be shown a list of available SCSI Adapters. This list should
include
“
Intel(R) 82801HEM SATA RAID Controller(ICH8M-E)
”
when the system
is in RAID mode and
“
Intel(R) 82801HEM SATA AHCI Controller(ICH8M-E)
”
or
“
Intel(R) 82801HBM SATA AHCI Controller(ICH8M)
”
when the system is in
AHCI mode.
7. Select the appropriate Intel RAID controller and press ENTER.
8. The next screen should confirm that you have selected the Intel
®
RAID
controller. Press ENTER again to continue.
9. You have successfully installed the Intel
®
Matrix Storage Manager driver, and
W indows setup should continue.
10. Leave the disk in the floppy drive until the system reboots itself. W indows
setup will need to copy the files from the floppy again after the RAID volume
is formatted, and W indows setup starts copying files.
7356v1.0-C_ICH9R RAID.p65
2007/5/22,
下午
05:30
9