vii
MS-AC22
Safety Instructions
Read the safety instructions carefully and thoroughly.
All cautions and warnings on the equipment or user’s manual should be
noted.
Keep the User’s Guide that comes with the package for future reference.
Keep this equipment away from humidity and high temperature.
Lay this equipment on a reliable flat surface before setting it up.
Make sure that the power voltage is within its safety range and has
been adjusted properly to the value of 100~240V before connecting the
equipment to the power outlet. Do not disable the protective earth pin
from the plug. the equipment must be connected to an earthed mains
socket-outlet.
Always unplug the AC power cord before installing any add-on card or
module to the equipment.
Always disconnect the AC power cord or switch the wall socket off if
the equipment would be left unused for a certain time to achieve zero
energy consumption.
◙
◙
◙
the ventilator on the enclosure is used for air convection and to prevent the
equipment from overheating. Do not cover the ventilator.
Do not leave the equipment in an unconditioned environment with a storage
temperature above 60
o
C (140
o
F) or below 0
o
C (32
o
F), which may damage
the equipment.
note: the maximum operating temperature is around 40
o
C.
CAUtIon:
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer.
the optical storage devices are classified as CLASS 1 LASeR PRoDUCt. Use of
controls or adjustments or performance of procedures other than those specified
is prohibited.
Do not touch the lens inside the drive.
1.
2.
never pour any liquid into the opening that could damage or cause electri-
cal shock.
Place the power cord in a way that people are unlikely to step on it. Do not
place anything on the power cord.
When installing the coaxial cable to the tV tuner, it is necessary to ensure
that the metal shield is reliably connected to protective earthing system of
the building.
Cable distribution system should be grounded (earthed) in accordance with
AnSI/nFPA 70, the national electrical Code (neC), in particular Section
820.93, Grounding of outer Conductive Shield of a Coaxial Cable.
Always keep the strong magnetic or electrical objects away from the equip-
ment.
If any of the following situations arises, get the equipment checked by ser-
vice personnel:
the power cord or plug is damaged.
Liquid has penetrated into the equipment.
the equipment has been exposed to moisture.
the equipment does not work well or you can not get it work according
to user’s manual.
the equipment has dropped and damaged.
the equipment has obvious sign of breakage.
◙
◙
◙
◙
◙
◙
廢電池請回收
For better environmental protection, waste batteries should be collected
separately for recycling or special disposal.
