Hardware Setup
▍
MS-91F7
2-7
Hardware Setup
▍
MS-91F7
Installing Memory Modules
The memory module has only one notch on the center and will only fit in the
right orientation.
Insert the memory module vertically into the DIMM slot. Then push it in until
the golden finger on the memory module is deeply inserted in the DIMM slot.
The plastic clip at each side of the DIMM slot will automatically close when
the memory module is properly seated.
Manually check if the memory module has been locked in place by the DIMM
slot clips at the sides.
Important
You can barely see the golden finger if the memory module is properly inserted
in the DIMM slot.
Notch
Volt
Important
To enable successful system boot-up, always insert the memory modules into
the
DIMM_A1 first
.
If users intend to install two DIMMs, it is highly suggested that these DIMMs
are populated in DIMM_A1 and DIMM_B1 for enhanced Dual-Channel mem-
ory performance.
In Dual-Channel mode, make sure that memory modules of the same type and
density are installed in different channel DIMM slots.
1.
2.
3.
•
•
•
