MS-7507 Mainboard
2-6
10. Align the holes on the mainboard
with the heatsink. Push down the
cooler until its f our c lips get
wedged int o t he holes of t he
mainboard.
12. Turn over the mainboard to con-
firm that the clip-ends are cor-
rectly inserted.
11. Press the four hooks down to fas-
ten the cooler. Then rotate the lock-
ing switch (refer to the correct di-
rection marked on it) to lock the
hooks.
9. Press down the load lever lightly
onto the load plate, and then se-
cure the lever with the hook under
retention tab.
locking
switch
Important
1. Read the CPU status in BIOS (Chapter 3).
2. Whenever CPU is not installed, always protect your CPU socket pin with the
plastic cap covered (shown in Figure 1) to avoid damaging.
3. Mainboard photos shown in this section are for demonstration of the CPU/
cooler installation only. The appearance of your mainboard may vary depend-
ing on the model you purchase.
7507v1.0CH2 Hardware Setup.p65
2007/12/7,
下午
03:24
6
Summary of Contents for 945GCM7 series
Page 1: ...i 945GCM7 series MS 7507 v1 X Mainboard 7507v1 0 0 Preface p65 2007 12 7 下午 03 22 1 ...
Page 6: ...vi 7507v1 0 0 Preface p65 2007 12 7 下午 03 22 6 ...
Page 7: ...vii 7507v1 0 0 Preface p65 2007 12 7 下午 03 22 7 ...
Page 59: ...3 24 MS 7507 Mainboard 7507v1 0 3_BIOS p65 2007 12 7 下午 03 25 24 ...
