2. Install the CPU
3. Install DRAM Modules
4. Install Expansion card
5. Connect Cables, Wires, and Power Supply
2-5 Jumper Settings
1. CPU Bus Frequency Selection : JP1
※
Users can also set the CPU Bus frequency and CPU ratio under “Frequency / Voltage Control
“of BIOS SETUP.
Table for the Socket370 Cpu
CPU Type
CPU Clock
Ratio
CPU Frequency
Celeron-300/300A
66 MHz
4.5X
300 MHz
Celeron-333
66 MHz
5.0X
333 MHz
Celeron-366
66 MHz
5.5X
366 MHz
Celeron-400
66 MHz
6.0X
400 MHz
Celeron-433
66 MHz
6.5X
433 MHz
Celeron-466
66 MHz
7.0X
466 MHz
※
Before install CPU please check the CPU Sepecification , and setting the correct CPU Bus
Frequency (Front Side Bus) and ratio in the “CHIPSET FEATURES SETUP” of BIOS
SETUP.
2. CMOS RAM Clear: JP13 (Yellow color selector)
WARNING: Make sure your computer is POWER OFF when you CLEAR CMOS.
Connect a jumper Cap over this jumper for a few seconds, will clears information stored in
the CMOS RAM Chip that input by user, such as hard disk information and passwords.
After CLEAR CMOS, you must enter the BIOS setup (by holding down <DEL> during
power-up) to re-enter BIOS information (see BIOS SETUP).
Selections
JP13
Normal
1-2 Default for R.T.C.
Clear CMOS
2-3 Reset R.T.C.
6
