8. POWER SUPPLY CONNECTION
The connections that follow must be performed with the lift in off position:
•
Connect the flexible hose, coming from the pneumatic supply, to the pump – be sure that the
inlet pressure is between 8 to 10 bars. Check that the pneumatic system has been prepared with a
correct condensate drying system.
•
Connect the pump flexible hose to the cylinder verifying that the coupling is correctly inserted.
9. INITIAL STARTING AND OPERATION
After learning the control functioning, connect the power supply and proceed with the following
actions:
RAISING:
•
PLEASE BE SURE THAT THE VEHICLE WHEELS ARE AT THE PROPER PRESSURE TO USE AS
INDICATED BY THEIR MANUFACTURER OF THE VEHICLE
•
Be sure of the efficiency of the parking brake before lifting the vehicle.
•
Be sure of blocking the vehicle using the parking brake.
•
Position the lift in such a way that the fork completely fits to the tire sides. If you use a clamp
to repair the vehicle sheet be sure of its correct positioning.
•
Be always sure of the correct positioning of the lifting arm before lifting the load.
•
Press the pump pedal - side A (see drawing 2) - to lift the vehicle to the desired height.
•
After reaching the desired height, release the pedal and put the load under safety inserting the
supplied pin in the hole in the column.
•
Press the pump pedal - side B (see drawing 2) - to let the trolley of the lift lean on the safety
pin.
LOWERING:
•
Press the pump pedal – side A (see drawing 2) to release the trolley from the safety pin.
•
Take the safety pin away from the hole where it was inserted in.
•
Press the pump pedal – side B (see drawing 2) to lower the vehicle at the desired height or to
the ground.
•
Take the lift away from the vehicle.
•
Now you can move the vehicle away.
ATTENTION!!!!
After
working or for a protracted stop
EASY LIFT 3000 must be brought to its rest
position.
Never leave the load in upper or in standing position without operator.
PICTURE 2
17
Summary of Contents for EASY LIFT 3000
Page 8: ...20 ...
