MSG MS015 COM, User Manual

Page: 11 / 57

9
WARNING! Contact the MSG Equipment support team in case you want to connect the type of
alternator which is not on the list.
1. The tester is intended for indoor use. When used outdoor, external conditions and technical
characteristics of the device set out in item 2 of this manual, should be taken into consideration.
2. To avoid damage or failure of the tester, do not make any changes in the electrical diagram of
the device. In case of failure, please contact Technical Support or a sales representative.
3. The device enables to test the alternator assembly either directly on the car or on the test
bench, which provides its drive. Further on, the option of testing the alternator directly on a car
will be looked into. Diagnostics with the test bench is performed quite the same way.
1. Only the personnel that has received special training in safety operation and been authorized
to work with the particular equipment is allowed to use the device.
2. Make sure that measuring clamps do not have insulation damage or bare metal spots. Check
the clamps for any breaks. In case of obvious damage, replace them with new ones before
launching the device.
3. In order to avoid possible electric shock or injury as well as damage to the tester, do not apply
voltage exceeding 20V to the device outputs (or between the earth and any of the outputs).
4. When measuring, try to connect outputs correctly, especially “B-“ones. The device has all kinds
of protection against emergency situations, however not all voltage regulators have such a
protection.
5.1 Safety measures
5. INTENDED USAGE
5). An oscilloscope is displayed on the screen and shows the measured signal and its waveform.
The measured signal is displayed on two scales: 20 and 200ms. Single-click on the diagram to
switch from one scale to another.
User Manual - MS015 COM Tester
English