MSG MS013 COM, User Manual

Page: 18 / 28

18
6.3 "PWM" mode (PWM generator)
In this mode:
• Select the option in the adapter's menu with the buttons "⇧", "⇩".
• Enter the testing mode with the button "⏎".
• Connect the wires "GC" and "-" from the adapter’s outputs to the controlled device.
• To change the duty cycle, press the duty cycle set area on the screen. The numbers will be
lightened by another color. Set the needed duty cycle value with the buttons "⇧", "⇩".
• To change the frequency, press the frequency set area on the display. The numbers will be
lightened by another color. Set the needed frequency value with the buttons "⇧", "⇩".
• Exit the testing mode with the button "⏎". Disconnect the wires.
6.4 "Oscillograph" mode
In this mode connection to the source of analized signal is carried out with the help of the four-core
cable using the wires with black (negative) and yellow (GC) color marking.
• Select the option in the adapter's menu with the buttons "⇧", "⇩".
• Enter the testing mode with the button "⏎".
• Connect the wires "GC" and "-" from the adapter’s output to the signal source.
• The results will be oscillographically displayed on the display of the adapter.
7. SAFETY MEASURES WHEN WORKING WITH MS013 COM
In order to avoid possible electric shock or injury as well as damage of the adapter or a tested
equipment, the following instructions should be strictly observed:
• Make sure that the measuring clamp does not have insulation damage or bare metal spots.
Make sure that the clamp is not damaged. In case of obvious damage, change it for a new one
before using the adapter.
• In order to avoid possible electric shock or injury as well as damage of the adapter, do not apply
voltage exceeding 20V to the adapter outputs or between the earth and any of the outputs.
User Manual - Adapter MSG MS013 COM