+
__
-
-
1.
2.
+
4. Daisy Chaining
If daisy-chaining, be sure to also
connect the wires going to the
next speaker in the chain. Follow
standard protocol for polarity and
make sure the subwoofer is wired
with the same polarity as the
Periscape units.
1. Install Cap
Install the cap by threading it onto
the end of the port tube clockwise.
Daisy Chaining Wiring
Wire Nuts
Speaker or
Subwoofer
Daisy-Chained
Speaker or
Subwoofer
Signal Wire
3. 70V Applications
For 70V (or 100V) applications,
select the appropriate tap wires
from the chart on page 3 and
connect them to the input wire from
the amp. Skip to step 5 if using 8
ohm.
3” to 5”
8. Complete Install
Place subwoofer in hole and fill.
Leave 3-5” of space from the
bottom of the cap to the ground.
Gray
Green
White
8 Ohm -
Red
8 Ohm +
8 Ohm Wiring
Heat Shrink Cap
5. 8 Ohm Operation
Locate the red, gray, green, and
white wire pairs and cut off the heat
shrink cap on each pair. Use the
supplied wire nuts and connect the
positive (+) lead from the amp to the
red wire and connect the negative
(-) lead from the amp to the white
wire. Do not use the gray or green
wire. Disregard if using 70V Wiring.
7. Trim Wires
Trim unused wires on the
subwoofer and wrap the loose ends
with electrician’s tape or a suitable
alternative to protect the bare wires
from corroding.
6. Test
Fully wire the rest of your system
and test to make sure sound is
coming from each unit.
1. Digging
Dig a hole sufficient to bury the
Subscape so that there is 3-5”
clearance between the bottom of
the port and the ground level. Be
sure to account for several inches
of gravel at the bottom to assist with
drainage.
SUBSCAPE INSTRUCTIONS
