MSC C10-MB-EV
User Manual
29 / 42
4.10.3 USB Client Connector
The USB Port 7 signals were switched to a 5 pin header, if a USB client is plugged at
X1903.
Specification:
References:
X1903
Connector:
single row pin header
Pin-out: Refer to Table 14
Location: Refer to chapter 4.10 USB Topology
Pin
Signal
Function
1
VCC_IN_CLIENT
Power in
2
USB_P7_N
USB port 7 negative signal
3
USB_P7_P
USB port 7 positive signal
4
GND
Power Ground
5
GND_SHLD
Ground Shield
Table 14 USB Client Connector
4.11 Ethernet
The base board can be connected to a local area network with an Ethernet interface. The
COM Express module already provides MDI signals, so that only the transformer on the
base board required. The transformer is integrated in X702.
Specification:
References:
X702
Connector:
Würth 749110616 (RJ45LAN 10/100/1000 BaseT + USB 3.0)
Pin-out: Refer to IEEE Std. 802.3
[9, section three, page 225]
Location: Refer to chapter 4.10 USB Topology
Color
Status
Description
Yellow
Off
No link
Yellow
Blinking
Link established, activity detected
Green/Orange
Off
10 Mbps
Green
On
100 Mbps
Orange
On
1000 Mbps
Table 15 LAN LED Description
Summary of Contents for COM Express MSC C10-MB-EV
Page 1: ...User Manual COM ExpressTM Mini ITX Carrier MSC C10 MB EV Type 10 Pin out Rev 1 0 2018 10 24...
Page 8: ...MSC C10 MB EV User Manual 8 42 2 2 Block Diagram Figure 1 Block Diagram Carrier Board...
Page 42: ...MSC C10 MB EV User Manual 42 42 4 28 Layout Revision The layout revision can be found here...