TAL 114 (L) Rev. 4 - 10090982
CHARGING THE BATTERY PACK
the case is cracked or distorted. Do
not use a damaged charger. Doing so
can result in serious personal injury
or death, or create a fire hazard.
1. Line up the key
in the charger
cable plug with
the slot in the
female connector
on the battery
pack.
2. Push the plug into the female con-
nector and turn the ring to secure
it.
3. Plug the charger into a 115-120 V,
50, 60 Hz (standard AC) outlet. The
charger can be used internationally
with the appropriate adapter.
Voltages lower than 115V are not
recommended. Voltages greater
than 120V will damage the battery
charger and battery pack.
4. Charge the battery pack until a full
charge is indicated.
The charger uses one LED. When the
battery is charging, the LED will be
Red. When the LED is Green the bat-
tery is fully charged. The battery can
stay connected to the charger until it
is needed. If the LED is Amber, the
battery is not at the proper tempera-
ture. The charging will start when the
battery pack reaches the optimum
charging temperature of 35°F to 100°F.
If the LED is flashing Red, there is a
failure. Disconnect battery pack, and
unplug charger. Plug charger back into
outlet and reconnect battery pack to
reset charger. If LED flashes Red dur-
ing any part of the charge, after it has
been reset, remove the battery from
service.
10
LED Signaling
Condition
LED Indication
Rapid Charge
Red
Charge Complete
Green
Charge Pending
Amber
Charge Failure
Red Flash
No AC or No Battery
OFF
Visit: www.thesafetyequipmentstore.com Or Email: [email protected] for Sales & Service.
