Version 3.4
10
NC-217
Operating manual
Figure 7 – Connection of AU-106 (alarm actuation by closing of relay contacts)
Figure 8 – Connection of AU-106 (alarm actuation by opening of relay contacts)
Figure 9 describes an assignment of jumpers on the Product’s PCB:
Data input ports “OUT1” to “OUT12”, “DATA_I/O1” and “DATA_I/O2” are
outfitted with Rt jumpers (JP4, JP5, JP6, JP7, JP8, JP9, JP10, JP11, JP12, JP13, JP14, JP15,
JP17, JP18) resistors-terminators 120 Ohm, used to match interface lines RS-422, and ter-
minals JP41, JP47 etc., connected in parallel to the corresponding lines of output ports and
intended for service check of output data test;
JP1 (Master), JP2 (Slave2), JP3 (Slave1) – service terminals are not used;
JP16, JP19 – select of interface type (RS-232 or RS-422/485) for the main and
standby channel.
