4.3
Neck Protector (GA3709)
Installation
(1)
Place the neck protector upside down above the helmet.
(2)
Insert the central clip (B).
(3)
And continue with (A) and (C).
Removal
(1)
To remove the neck protector, release the clips by pressing them.
4.4
Headlamp
If the headlamp is removed from the helmet, the following components should be installed.
Front plate (GA3707) to replace front module, and rear cover (GA3706) to replace the rear module.
For further information see the head lamp user manual.
4.5
Water Rescue Lateral Protection Panel (Option) (GA3701)
The water rescue protection panel enables helmet full compliance to EN 1385:2012 standard (helmets for canoeing) by
increasing the area of protection to the side (GA3701).
WARNING!
Do not use the helmet for water rescue protection without the lateral protection panel.
Failure to follow this warning can result in serious personal injury or death.
Installation
(1)
Insert the front edge in its groove and push the rear clip through the slot until it
clicks. Repeat the operation for the other side
Removal
(1)
Push the rear clip
and pull it down
to release it completely from its slot.
Repeat the operation for the other side.
For an overview of the available accessories, see section
.
12
US
4 Accessories